S-11 series potentiometer fiber amplifier

S-11 series potentiometer fiber amplifier, it's a low cost and very easy for setting parts. it with potentiometer for adjusting sensitivity, LED light display working status.

1. Stuitable for universal application, potentiometer adjustment.
2. Low cost, high-performance.

Light Source	Red LED (625nm)
NPN OutPut	S-11
PNP OutPut	S-11P
Supply voltage	12-24VDC ±10% ripple P-P10% below
Current consumption	Less than 960nW 40mA or less
Detection output	NPN output type: NPN open-collector transistor Maximum sink current: 100mA Voltage：30VDC or less（when detecting or between 0 to 30 VDC) Residual voltage: 1.0V or less (current 50mA) ,4 V (current 50mA)
Detection output	PNP output type: PNP open collector transistor Maximum flow current：100mA Voltage：30VDC or less（when detecting or between 0 to 30 VDC) Surplus voltage: 2.0 V or less (current 100 mA),1.0 V (current 16 mA)
Output operation	Detecting ON or not detecting ON , ON/OFF switch choice.
Short circuit protection	Polarity protection / Circuit protection
Indicator	Power light: green, Output light: orrange
Sensitivity function	8 circles turn adjusting
Loading current	100mA Max.at DC 24V
Isolating impedance	20M Ω min.(DC500V)
Insulation compression	AC500V 60Hz for 60sec
Protection level	IP63
Reaction time	400μs below
Detection distance	Reflex： 100mm through-beam：400mm
Reaction time	0.5ms or less（（Resistance interference function 0.7ms or less）about 250μs
Timer function	about 40ms OFF Delay time
Operating environment temperature	-10~+50℃ （no-freezing,no-dew） Storage：-20~+70℃
Operating environment humidity	35~85%RH , Storage：-：35~85%RH
Material	Shell: heat-resistant ABS, cover: polycarbonate, optical fiber fixed rod: PPS
Accessories	--