green cutting disc

The green cutting disc is not only important in the operation method, but the important point in its use is that it is installed and installed, and its working efficiency is also high. However, if the installation is not good, it will have an impact on its use. Next, the Aurora Abrasives will give you an analysis of the serious impact of the improper installation of green cutting disc.

1. Shock: This is because when the cutting piece is running at high speed, the vibration is severe when the handle is held, the cutting efficiency is lowered, and waste is caused. The reason is caused by the imbalance of the cutting piece.

2, bridge: it is a film. When the cutting piece is running at high speed, the trajectory cannot be straight, and the direct result is that the material after cutting has a slanting flaw, which may not meet the processing requirements.

3, it will crack, broken: This is due to the inferior quality of the mesh, the amount of binder is too small or expired, the temperature of the furnace is too low, etc., causing cracks in the cutting piece during high-speed operation, and crushing injury in severe cases. people.

If the cutting piece is not properly installed, it will not only affect your work efficiency but also even affect your personal safety. Therefore, users must pay special attention to the installation.