Walk Through Metal Detector ThruScan s6

Conforms with European Norms NILECJ-0601.00 L1-5 Standard and produced under ISO 9001: 2008 QMS 

Electromagnetic Field-EMC conforms to International Health and Safety Norms 

Capable to Detect both Ferrous and Non-Ferrous Metallic Threat Objects Considered Dangerous by International Security Authorities.

Can detect when tested both individually and in combination.

Gives Alarm to all threat objects detected in different Alarm Zones.

Detects all threat objects even those hidden with camouflage, concealed and/or wrapped. Impossible for such threat objects to pass through the WTMD without causing an alarm.

No Interferences between Zones and No False Alarms

ThruScan/s6 Multi-Zone - 6 Matrix Detection Zones (Up/Middle/Down and Left/Right)

Homogeneous Magnetic Field – No Dead Points – Same Detection Capability from bottom to top

10 sensitivity levels, 246 adjustable sensitivity steps at each + 1 standard pre-set international security program

Auto Calibration (Automatically calibrates itself to Environmental Conditions) No Set Up Changes necessary when relocated and/or new Magnetic Objects brought Near-By 

Human Health friendly Very Low Frequency VLF technology, No affects to Pace Makers, Pregnant and Magnetic Media

Green/Red traffic control LEDs allow to enter 30 Persons / Min.

Superior Discrimination, Precise target location identification / Graphic zone display on Control Unit

Metal Density-Mass, Signal Strength Display at 10-level-VU meter with green, yellow, red LEDs easily allows sight from distance

Digital Environment magnetic noise level and visual detection and Error Code Display on Wide 4x20 Characters LCD Screen 

Adjustable audio alarm at 10 tons/level or Soundless (Mute) operation.

Five Digit Incoming Counter (Visible/Invisible)

Alarm Counter (Five Digit)

IR Pass Sensor On / Off selection

Four-digit changeable digital Pin Code

Automatic Failure Display with Continuous Self-Checking of Key Parameters. (BITE – Built-in Test Equipment)

Reloading the factory default settings by one-touch button

Easy programming and monitoring with wide LCD display

4 Menu Languages, Standard menu in English, German, Spanish and Turkish

Relay output for recording CCTV, Photo Recording, controlling turnstiles, etc. on Alarms

OPTIONAL -Uninterrupted Power Supply (UPS) enabling 2 hours operation without mains

No seasonal adjustment requirement thanks to its Digital Electronic System (DSP)

Easy-to-mount and assemble walk through metal detector (15 Minutes) Male/Female Socket-Connector Design 

IP 20 (Optional IP 65) Protection Level (EN 60529) 

Manufactured for 7/24 Continuous Operation

74 cm Net Passage Width and 200 cm Net Passage Height

Interference free Operation at Middle Level Sensitivity of 10 cm Distance Constant Metals and 200 cm distance Moving Metallic Objects 

Audio-Visual alarms are noticeable at a range of 2 meters

Micro-Processor Settings do not change when there is an electricity cut-off

Corrosion Resistant Metal Footers for sturdy placement and durable use.

In conformity to CE , Certified in Compliance to EN 61000-6-3, EN 61000-6-1 regulations and in compliance with DIRECTIVE 2002/95/EC (restriction of the use of certain hazardous substances in electrical and electronic equipment)