Nowadays, many factory equipments need to be processed and polished before leaving the factory to ensure that their appearance and shape meet the requirements of use. Therefore, abrasive tools are very important, 105*1.2*16 cutting disc are one kind, it is Consumable products consume very quickly, so it is important to speed up its hardness, wear resistance and cutting speed, so the cutting chip manufacturers analyze the influence of the shape and balance of the grinding wheel on the performance of the 105*1.2*16 cutting disc.
Experts have found that when the thickness is large, the slit is wide and the grinding wheel is expensive; when the strength is guaranteed, the smaller the thickness, the better, saving the material of the grinding wheel and saving the material to be cut; when the flatness is large, the width of the slit is determined by the thickest part. The strength is determined by the thinnest part. The wear is large and the vibration is large when cutting. It will affect the whole cutting process. When the thickness of the grinding wheel is large and the thickness is small on the edge, the side of the grinding wheel will be cut and the workpiece will be cut during the cutting process. The same is called "dead", so the grinding wheel can be made thin in the middle, and the surrounding thickness is the rational state. When the grinding wheel end is large, the cutting will swing back and forth, and the cutting width is large. The material to be cut is unnecessary to consume, and the grinding wheel consumes naturally. Big, big impact.